Omega Long Chassis Hydraulic Service Jacks are designed to lift, but not sustain, rated capacity loads. Each is designed to be used in conjunction with jack stands. Intended use: To lift one axle of a vehicle for the purpose of service and/or repair of vehicle components. After lifting, loads must be immediately supported by appropriately rated jack stands. Check with vehicle owner's manual for proper lift points. Those air actuated units require at least 7.8 CFM @ 90 - 175 PSI.

Features:

• Handle actuated release valve provides precise metered control of lowering speeds.
• Wide stance and low center of gravity provide optimum stability under load stress.
• Heavy gauge, steel frame helps prevent distortion or twisting.

Specs:

• Capacity(Ton): 10
• Min. Height: 7"
• Max Height: 27"
• Handle Length: 42-1/8"
• Saddle Diameter: 7-3/8"
• Jack Side Length: 55-1/2"
• Jack Size Width: 20"
• Jack Size Height: 12-3/4"
• G.W.(lbs): 436

CATEGORIES OME-22100 IN: Omega, Long Chassis Service Jack